Description
There is no need to buy a whole new board when you only need a new cover. These replacement covers are specially designed to fit the Sleeve Ironing Board. There are two sizes included, one for each surface size. Make your board last even longer with the Sleeve Ironing Board Replacement Covers.
Simply untie the existing cover and remove both the cover and foam backing. Place the new foam on the board. Then lay the cover flat and center it over the foam and board. Take hold of the string on one end of the cover. Starting from the opposite end, fold down the sides of the cover and gently pull the string out, securing the cover on the board. Tie the string off and your Sleeve Ironing Board is just like new again!
- Two sizes – 21″ x 5″ and 19″ x 5″ covers and foam included.
- Teflon-coated for a smooth ironing surface.
Each package includes 2 Replacement Covers and 2 foam backings.
James –
It fit like a glove as a replacement for the original cover. Will buy again if I ever ware this one out.
Kate (verified owner) –
This cover was a piece of junk
basssinger –
These covers are very poor quality. The cover material is very thin. The string is very thin and fine, making it hard to pull the cover tightly around the sleeve board for fear the string will break. The cover will still have wrinkles.
These 2 covers are the same size. I have a sleeve board with a narrow side and and wide side. I actually needed a cover for the wide side and didn’t understand that this package was 2 of the same size rather than 1 of each size. I did refresh my narrow side with one of these covers, but I put it over the old cover because the foam is not big enough to cover my narrow side. All in all, don’t waste your money!
Judy (verified owner) –
The Sullivan covers are really poor quality. The cover material is very thin. The string is so thin and fine that it is difficult to pull the cover tightly around the sleeve board without breaking the string. The cover will still have wrinkles. These 2 covers are the same size. I have a sleeve board with a narrow board and a wide board. I actually needed a cover for the wide board and didn’t understand that this package was 2 of the same size rather than 1 of each size. That needs to be explained more explicitly in the information online. I did refresh my narrow board with one of these covers, but I put it over the old cover because the foam is not big enough to completely cover the narrow side. Since I had to pay shipping as well, I would have been better off purchasing a new board. I am not at all impressed with the quality of this Sullivan product.
Emma –
I have been looking for a real small cover, but I’ve never seen one until now. I’m very pleased..
Martin –
Perfect. Just perfect for the job.
Marilyn (verified owner) –
Is worthless. Does not fit. Both sections were basically the same size and does not even fit the small side of my board. The edges do not even go but about 1/4″ around the edge which makes it unusable as it doesn’t tuck under and slips right off. If I could give negative stars I would.
Randy Dodd (verified owner) –
Very small. Material is very thin. Foam is minimal. It did not fit my sleeve board. Hard to attach to sleeve board as it does not wrap around all sides and back. Overall, not good. I did measure before I ordered. Not sure how this would fit a 21″ board.